TACHOMETER OIL TEMP AMP FUEL GAUGE SET PACKAGE for FARMALL 240

Fits Farmall / IH Tractor: Farmall 240 Row Crops 

This listing is for a aftermarket Farmall 240 row crop tachometer and aftermarket four gauge set in the picture. The tachometer has a 5/8" UNF cable end and has 6 or 12v light also. The Farmall part number it replaces is 371276R92. The diameter of the tachometer is 3 3/8" (85mm).

If your looking for the tachometer cable that goes with this tach, and would like to purchase one.

These gauges have Yellow Zinc "Cad" plating for corrosion resistance protection! Gauges have mounting studs and brackets, rubber gasket seal for mounting flush to dash. Chrome raised bezel, Gauges also have a 6 or 12 V light feature included so owner has option to use or not to use! Dash hole diameter for gauges are 2" / 52mm.

Temperature gauge: replaces IH part numbers 353868R91, 53690R2, 369849R91, 393476R91 

IH Farmall Water temperature gauge is measured in 3 zones. Water temp gauge includes a 72" spring covered capillary

lead. 5/8-18 U.F. END W/ 1/2" NPT PIPE BUSHING

Oil pressure gauge: replaces IH part numbers 362039R93, 362177R94 and 536696R2. 

The gauge has 1/8" NPT male fitting, 

I also sell a Farmall IH Tractor Oil Pressure Gauge Copper Tubing Line Kit! This will make easy installation

Amp gauge: replaces IH part numbers 360053R91, 378424R91 and 393334R1

Fuel Gauge:  replaces 371056R91 also fits 371056R92

Fits Farmall / IH Tractors: International 240 

This is for a Rochester style gauge, 0-70 Ohm's. Will not work with Stewart Warner sending unit (32 Ohm full to 244 Ohm empty) 2" / 52mm Dashboard Hole


Range = Empty - Full,     Gauge works with 6 or 12 volts

 Before you buy this gauge and then install the fuel gauge. Get a good electrical manual for your machine from the manufacture. You need to be 100% sure of your fuel gauge wiring circuit is 100% correct! and whether or not the correct sending unit is in the existing fuel tank examples: universal sending unit with improper ohms and or wiring, custom units because original is no longer available, other manufactures have different ohms.(a lot of things happen to these tractors in 60 years, I see it on the restorations that I do from time to time). I can not return so called defective electrical units to manufacture that are hooked up incorrectly. I will only take gauge back if it has not been installed and you pay the shipping! Or If it is TRULY DEFECTIVE!! Most of the sales are without issues because proper installation has been followed. I am a 33 year ASE Master Tech myself and I run into a lot of splicing and rewiring of tractors. Also other different parts used from other models. 

A separate ground wire is needed from sending unit and the gauge to engine / frame ground because of tank being mounted on rubber washers! I have seen problems with this ground system! Too much paint causing no / poor ground.

Tractor: Farmall / IH International 240 and others

Gauge works with 12 volts!

From what I am told and what I have found out on my own 240's  that the gauge sending unit is not available for these 240's. I am informed that the gauge sending unit that will work for these 240's is purchased through local Case IH dealer. It is for a 444 or 2444 fuel tank and was part # 84270826. It cost about $60.00. Look it up on Case IH's website.  If you use this one keep in mind that one of the bolt holes is located off a little bit so it fits only one way when mounted. 

IHTMP72

IHO362039R93 SM

IHA360053R91

IHF371056R91

IHTCHF240

Disclaimer:

Tractor America parts listed are Aftermarket parts and not manufactured by the (OEM) Original Equipment Manufacturer. Original manufacturers names, logos, part descriptions and numbers are for reference purpose only. This does not intend, indicate and or suggest that our parts are manufactured by the original equipment manufacturer(s).

All Tractor America Aftermarket listed parts are "Compatible with" will "Fit" and or made "For":  Farmall, IH, International Harvester, Ford, Allis Chalmers, Massey Ferguson, Massey Harris, Oliver, Cockshutt, Minnieapolis Moline, Willys, MB, jeep, Case-IH, Case, David Brown, John Deere, JD, Kubota, New Holland, NH, Avery, Long, White, Perkins, Volvo, Oregon, Leyland, Iveco, Fiat, Honda, Exmark, Stihl, K&N, MTD, Scag, Wright MFG., Murray, Wizard, Western Auto, Troy Built, Rally, Cub-Cadet, Ariens, Atlas, Techumseh, Husqvarna, Bobcat, E-Z-Go, AYP, Fiat Hesston, NGK, Champion,  Hinomoto, Deutz Allis, GM, Chevrolet, Craftsman, Poulan, Mitsubishi, Uniiversal, McCormick, CNH, MTD, Yanmar.