Fuel Gauge for IH International 444 2444 Industrial

This listing is for a International IH 444, 2444 Industrial fuel gauge. This is for a Rochester style gauge. Will not work with Stewart Warner sending unit (32 Ohm full to 244 Ohm empty) 

This 2" / 52mm diameter gauge has Yellow Zinc "Cad" Plating for corrosion resistance protection. Gauge also has mounting studs and bracket, rubber gasket seal for mounting flush to dash. It has a light feature included so owner has option to use or not to use.                                                                                                                                                                                         

Fits IH Tractors: IH International 444, 2444 Industrials

Gauge works with 12 volts!

"This gauge is custom calibrated closer than the standard OEM gauge"

Before you buy this gauge and then install the fuel gauge: Get a good electrical manual for your machine from the manufacture. You need to be 100% sure of your fuel gauge wiring circuit is 100% correct! and whether or not the correct sending unit is in the existing fuel tank examples: universal sending unit with improper ohms and or wiring, custom units because original is no longer available, other manufactures have different ohms.(a lot of things happen to these tractors in 60 years, I see it on the restorations that I do from time to time). I can not return so called defective electrical units to manufacture that are hooked up incorrectly. I will only take gauge back if it has not been installed and you pay the shipping! Or If it is TRULY DEFECTIVE!! Most of the sales are without issues because proper installation has been followed. I am a 33 year ASE Master Tech myself and I run into a lot of splicing and rewiring of tractors. Also other different parts used from other models.

From what I am told and what I have found out on IH 444's is  that the gauge sending unit is available for these. I am informed that the gauge sending unit that will work for these 444's & 2444 Industrial's is purchased through Stieners Tractor parts. It is for a 444 or 2444 fuel tank and I have been informed that the Stieners IHS1717 sending unit works well with this fuel gauge. If you use this one keep in mind that one of the bolt holes is located off a little bit so it fits only one way when mounted. The sending unit needs to have a additional ground wire that grounds sending unit to engine ground and gauge bottom center lug! Due to fuel tank mounted on rubber grommets and some painted surfaces! Otherwise gauge will not work! Some wiring harnesses do not come with the ground wires. Thanks!

Our # IHF444

Disclaimer:

Tractor America parts listed are Aftermarket parts and not manufactured by the (OEM) Original Equipment Manufacturer. Original manufacturers names, logos, part descriptions and numbers are for reference purpose only. This does not intend, indicate and or suggest that our parts are manufactured by the original equipment manufacturer(s).

All Tractor America Aftermarket listed parts are "Compatible with" will "Fit" and or made "For":  Farmall, IH, International Harvester, Ford, Allis Chalmers, Massey Ferguson, Massey Harris, Oliver, Cockshutt, Minnieapolis Moline, Willys, MB, jeep, Case-IH, Case, David Brown, John Deere, JD, Kubota, New Holland, NH, Avery, Long, White, Perkins, Volvo, Oregon, Leyland, Iveco, Fiat, Honda, Exmark, Stihl, K&N, MTD, Scag, Wright MFG., Murray, Wizard, Western Auto, Troy Built, Rally, Cub-Cadet, Ariens, Atlas, Techumseh, Husqvarna, Bobcat, E-Z-Go, AYP, Fiat Hesston, NGK, Champion,  Hinomoto, Deutz Allis, GM, Chevrolet, Craftsman, Poulan, Mitsubishi, Universal, McCormick, CNH, MTD, Yanmar.